Commercial
Lower Piston Assembly used on the Fleck 2900 and 2930 valves. This is the NHWBP version, DOES NOT permit Hard Water to Bypass the valve, during a regeneration cycle. This NHWBP (No Hard Water Bypass Piston), that will stop all water flow from getting past the control vavle, during the regeneration cycle. This Part can [...]
Fleck 9000 Control Valve Parts
Fleck Metered Timer Assembly – 9000, 120 volt 1/30 rpm – (60376-XX)
Used on Fleck Models 9000, 9100 & 9500 Twin Tank Metered Assembly. The program meter wheel is located on the front and timer motor on back of this assembly. Has the standard range program wheel showing 125 – 2,100 gallons. Plz contact us if your Assembly has one of these a higher gallon range lables [...]
Fleck 7000 Control Valve Parts
1ea – 7000 Connector Assembly, 3/4″ NPT w/O-ring (FL70-07PVC-SINGLE)
Adapter 3/4 inch NPT Noryl Connector w/oring – 42414-01 Used on the Fleck 7000 Control Valve
Fleck 9000 Control Valve Parts
Used on Fleck 2850 Control Valve
Complete Service Assemblies
Old Style Designer Cover used on Fleck 1500, 2500, 2510, 2700, 2750, 2850, 2900, 9000 , 9100 and 9500 Valves. Works with older valves that have the Thumbscrews on either side of the cover.
Fleck Control Valve Parts part number order
Stripped 9000 Injector Drain Module Body You may want to also order the four new “O” rings listed, that are installed between the Injector Body and 9000 Valve body. (We have found that “O” Rings over 5 years old will generally not reseal.) 1ea – 13302, 1ea – 13303, 2ea – 13301
Complete Service Assemblies
FLEC-DG New Style Cover with “Weather-Proof Seal, for Fleck 2850, 2900 & 9500 Fleck valves that have the special hinged back plate. Cover includes plastic hinge pin.
Fleck Control Valve Parts part number order
Backplate, used on the Fleck 2900 Valves. Uses “Environmental” cover, PN 60217-02
Fleck Control Valve Parts part number order
Upper Puller Tool Assembly, 2900, 3100 & 3150 Valves (FL12682)
Tool used to make removal of Seals and Spacers in the Fleck 2900 Valve easier.
Commercial
2900 Lower Drive Assembly 115v 2900 (Lower Drive Only, in Picture) Includes Fleck Part #’s…. 1. . . . . . . 10218 . . . Micro Switch 1. . . . . . . 10250 . . . Retaining Ring 1. . . . . . . 10302 . . . Insulator, Limit Switch [...]
Mineral Tanks Parts
Used on Calcite Mineral Tanks with No Thread – Dome Hole Opening, 1-1/4″
Complete Service Assemblies
Right Angle Meter Cap Only, Extended Range. This is the Extended Range Meter Cap Only, is used on the Right Angle PN 15452-90 This Extended Range Meter Dial on the Control Valve, will have numbers from 0 – 100 (0 – 10,000 gallons maximum capacity setting ).
Fleck Control Valve Parts part number order
Extended Meter Cover, 90 Degree, 3/4″, Right Angle (FL15569)
Special Order – 3/4″ Black Plastic Meter Dome, Extended Range, sometimes used on the Fleck 2500, 2510, 5600 and 8500 Metered Valves.
110,000 Grains
Fleck 9100 SXT Twin Alternating 1″ High Flow Meter110,000 GRAINS Capacity Per Tank Water Softener
Complete water softener comes with: 7.0 CUBIC FEET OF RESIN 110,000 GRAIN CAPACITY PER TANK (TOTAL OF 220,000 GRAINS) FLECK 9100SXT CONTROLLER 1 ” High Flow Meter TWO (14X65) MINERAL TANKS COMPLETE SYSTEM 55X18X73 inches BRINE TANK w/safety float
80,000 Grains
Fleck 9100 SXT Twin Alternating 1″ High Flow Meter80,000 GRAINS Capacity Per Tank Water Softener
Complete water softener comes with: FLECK 9100SXT CONTROLLER 5.0 CUBIC FEET OF RESIN 1 " High Flow Meter TWO (13X54) MINERAL TANKS 80,000 GRAIN CAPACITY PER TANK (TOTAL OF 160,000 GRAINS) COMPLETE SYSTEM 55X18X62 inches (18x40) BRINE TANK w/safety float
64,000 Grains
Fleck 9100 SXT Twin Alternating 1″ High Flow Meter 64,000 GRAINS Capacity Per Tank Water Softener
Complete water softener comes with: FLECK 9100SXT CONTROLLER 1 " High Flow Meter TWO (12X48) MINERAL TANKS 64,000 GRAIN CAPACITY PER TANK (TOTAL OF 128,000 GRAINS) COMPLETE SYSTEM 51X18X56 inches BRINE TANK w/safety float